Door Closer Repair Chelsea Fitting and Adjustment
We carry out door closer repair across Chelsea, adjusting slamming or slow closers, replacing leaking units and fitting new overhead closers to communal, fire and shop doors, usually arriving within 30 minutes in SW3 and SW10. A closer fitted or repaired costs £40 to £75, the lower figure for a standard daytime adjustment and the higher for nights, weekends or a heavier duty replacement. There is no call out fee, and the exact price is confirmed on the phone before we travel.
- DBS checked locksmith
- Public liability insured
- Over 5 years working in Chelsea
- Price agreed before work
- No call out fee
How an overhead door closer works
An overhead closer is a spring and an oil filled cylinder. When you open the door, the spring is compressed. When you let go, the spring pushes the door shut and the oil, forced through small channels, controls how fast it moves. Small screw valves on the body set the speed for each part of the closing arc.
- Sweep speed controls the door from fully open down to about 15 degrees from the frame.
- Latch speed controls the last few degrees, where the latch meets the keep. A little faster here helps the latch click home.
- Backcheck, on some models, cushions the door if it is flung open, protecting the wall and the hinges.
- Delayed action, on some models, holds the door briefly before it starts to close, useful for wheelchair users and deliveries.
The spring strength is the closer's power size. Light internal doors need a low size; heavy timber entrance doors and most fire doors need a higher one. A closer that is too weak will never latch a heavy door however the valves are set.
Door slamming: why it happens and how we stop it
A slamming door is the commonest closer complaint we hear, especially from ground floor flats beside a block's entrance. The usual reasons:
- Latch speed turned right up by someone trying to make the door latch.
- Oil thinning as the closer ages, so the valves no longer hold the door back.
- Seals failing, which shows as oil on the closer body or the floor below.
- Arm geometry wrong after a previous replacement, so the door gains speed at the end.
If the closer is sound, we reset sweep and latch speeds so the door closes steadily and still latches. If oil has leaked, adjustment will not last and the unit is replaced. Over winter, older closers often slow down as the oil thickens and speed up again in summer, so a borderline unit may need a seasonal tweak or replacement with a better grade closer.
Do not unscrew the valves too far
Turning an adjustment valve out too far can push it out of the body and release the oil, ruining the closer. Small quarter turns are all a closer needs.
Door closer repair prices
The closer itself is one price band, and related door and lock faults found on the same visit follow our list with no call out fee.
| Job | Typical price |
|---|---|
| Door closer fitted or repaired Adjust sweep and latch speed or fit a new overhead closer | £40 to £75 |
| Door repair (timber or front door, frame, hinges) Rehang a dropped door before the closer is set | £50 to £120 |
| Lock repair (stiff, jammed lock) Lock or keep that stops the door latching | £35 to £60 |
| Concealed or multiple closers Routing for hidden closers or several doors in one visit | Priced on the phone |
Prices include parts and labour. The lower figure is a standard daytime job, the higher figure covers nights, weekends and high security parts. Your exact price is confirmed on the phone before we travel, with no call out fee. See the full Chelsea price list.
When the door will not close or latch
| Symptom | Cause | Fix | Price |
|---|---|---|---|
| Door stops short and stays open | Closer too weak for the door or seals in the frame too tight | Higher power closer or eased seals | £40 to £75 |
| Door reaches the frame but latch does not engage | Latch speed too slow or keep misaligned | Adjust latch speed, move or file the keep | £40 to £75 |
| Door closes too fast and bangs | Valves set too open, or oil failing | Reset valves or replace leaking unit | £40 to £75 |
| Door catches on the floor or frame | Door dropped on worn hinges | Repack or replace hinges, then set the closer | £50 to £120 |
| Lock bolt drags after door closes | Lock or keep fault rather than the closer | Lock serviced and keep aligned | £35 to £60 |
A door that has dropped is a door repair first, and our door repair in Chelsea page covers hinges and frames. A lock that drags is covered on our lock repair page. We check both before blaming the closer.
Closers on fire doors and communal entrances
On a fire door the closer is not optional: it is the part that makes sure the door is shut when a fire starts. A flat entrance door onto a common stair, or a fire door on an office landing, must close fully and latch from any open position. That usually means a closer of adequate power, correctly set, with no wedge or hook holding it open.
Communal entrances in Chelsea's red brick mansion blocks are often heavy hardwood doors with glazed panels. These need a strong closer to pull them onto an electric release or a nightlatch, but not so strong that elderly residents struggle to open them. Getting that balance right is most of the job. If a porter or managing agent is looking after several doors, our mansion block locksmith service covers the whole entrance, and the fire door locks page explains the lock side of a fire door.
Concealed closers on Chelsea period doors
Many owners of Georgian and Victorian townhouses on streets like Cheyne Row, Glebe Place and the squares off the King's Road do not want an aluminium box on a painted panelled door. There are quieter options.
Jamb mounted chain closers
A spring cylinder recessed into the hinge edge of the door, with a chain into the frame. Invisible when shut. Suits lighter internal doors and is often used on fire doors in period conversions.
Concealed overhead closers
The closer body is set into the top edge of the door with a slide arm into the frame head. Stronger than a chain closer and still hidden when the door is shut.
Slide arm surface closers
Where a surface closer is acceptable, a slide arm in a track looks neater than a jointed scissor arm and suits shallow frames.
Fitting a concealed closer means routing into the door, so on fire doors the closer must be suitable for the door's rating. We check that before cutting anything.
Door closer repair for shops and offices
Shop doors on the King's Road and Fulham Road open hundreds of times a day, and closers wear faster than anywhere else. Narrow aluminium shop doors often use a transom closer hidden in the frame head or a floor spring under the threshold; both are adjusted with similar valves to an overhead closer. When a shop door will not close against the lock at the end of the day, the closer is usually the first thing we check.
A door that stays slightly open overnight is an insurance problem as well as a draught. If the closer has been fighting a sagging door, both are dealt with on one visit. Our commercial locksmith in Chelsea page covers the rest of the shop and office hardware, and Fulham shops are usually 20 to 40 minutes away. For a tighter home, our home security guide explains why a door that closes properly matters. All prices are on our price list, and other trades are on the locksmith services in Chelsea page.
Common questions
How do I stop a door closer from slamming?
The latch speed valve is usually set too fast or the oil is failing. A small quarter turn of the latch valve can slow it, but turning too far can release the oil. If the closer leaks oil it needs replacing, which we do for £40 to £75.
Why does my door closer leak oil?
The internal seals have worn. Once oil escapes, the closer cannot control speed and will slam or close unpredictably. Leaking closers cannot be refilled in practice, so the unit is replaced with one of the right power size.
Why will my door not latch with a closer fitted?
Usually the latch speed is too slow, the closer is too weak for the door, or the keep has moved. Tight smoke seals in the frame can also hold the door off. We check all of these before replacing the closer.
Can a door closer be hidden on a period door?
Yes. Jamb mounted chain closers and concealed overhead closers sit inside the door and frame, so nothing shows when the door is shut. They suit painted panelled doors in Chelsea townhouses. Priced on the phone because routing varies.
Is a door closer required on a fire door?
Yes. A fire door needs to close and latch on its own, so a working self closer is part of its design. Removing or disconnecting it weakens fire protection. See our fire door locks page for the lock side.
How much does a door closer repair cost in Chelsea?
Fitting or repairing a door closer is £40 to £75 with no call out fee. The lower figure covers a standard daytime adjustment; the higher covers nights, weekends or a heavy duty closer. We confirm the price on the phone first.
Related pages
Door slamming or not shutting?
Call 07520 643913 and we will agree the closer price on the phone before we come out.